Acid filter SUN SF 20.13
model SF 20.13
- Removal drops of acid and aerosolsolen in flue gas
- Reduction of acid dew point
- Prohibition of corrosion damages on gas analyzers
- High deposition rate of 99,99%
- Made in Germany
- Certificates: ATEX 2014/34/EU
The acid filter is designed for the removal of aerosols from the gas flow of predominantly emission measurements. This deals with floating liquid droplets (aerosols), which are deposited in a specially built filter matrix. This takes place with high efficiency because the gas flow is directed from inside to outside by the filter body. Here, the small liquid droplets are coalesced until large drops have formed, which sink in the filter element as a result of gravity and accumulate at the bottom of the glass tank. The service life of the filter element depends on the load of the measuring gas due to solids.
Installation of the acid filter in front of the measuring gas cooler.The acid filter must be mounted vertically. The condensate should be able to accumulate in the lower part of the glass tank. The gas connections are marked with arrows. The measuring gas outlet allows a variable immersion depth of the Teflon hose. The deposited liquid is carried along by the measuring gas outlet of the acid filter to the measuring gas cooler. For this, the hose must be inserted in the measuring gas outlet up to a few mm below the lower edge of the filter element in the flask (see image).
Gas flow diagram:
In case of large condensate quantities, the condensate can be disposed of manually using the enclosed connection or using an additional perestaltic pump.
|Scope of delivery:||Housing, filter element, assembly bracket|
|Materials used:||Borosilicate micro glass fibres, PVDF, Duran glass, PP, FKM|
|Operating pressure:||0 - 500 mbar|
|Gas flow:||0 - 300 l air/h|
|Pressure drop at 300 l air/h:||approx. 10 mbar|
|Operating temperature:||+ 5°C - +80°C|
|Housing dimensions:||Diameter 90 mm, length 185 mm|
|Housing volume:||135 ml|
|Effective filter area:||170 cm2|
|Gas connections:||GAS-IN 6/4 mm hose fitting
GAS-OUT 6/4 mm hose fitting
KONDENSAT-OUT 6/4 mm hose fitting
|Assembly:||Wall mounting with assembly bracket (included in scope of delivery)|
|Gas explosion proof ATEX:||EX II 2G Ex h IIB Gb -10°C ≤ Ta ≤ +80°C attestation EPS 19 ATEX 2 177 U|
|Language operating instructions:||German and English (included in the scope of delivery)|
|Spanish, Italian, French, Russian upon request|
|Certificates/attestations:||certificate of conformity ATEX 2014/34/EU|
For operation in potentially explosive ambience:
The products can be used in explosive ambience of Zone 1 and Zone 2.
Allowed the explosion classes IIA and IIB.
The products have no self-heating during intended operation and can be used in dependency of the maximum permissible media temperature for gases of the temperature class T6.
|Acid filter complete with retaining bracket and filter element||SF2013|
|1 pair (2 units) of filter elements, material borosilicate micro glass fibres||2FESF2013|
|5 pairs (10 units) of filter elements, material borosilicate micro glass fibres||10FESF2013|
|10 pairs (20 units) of filter elements, material borosilicate micro glass fibres||20FESF2013|
|1 unit of O-ring FKM||ORSF2013FKM|
Ordering information: Filter elements for acid filter can be offered only in pairs